P0630

P0630-VIN NOT PROGRAMMED IN PCM

For a complete wiring diagram refer to: Electrical Diagrams

When Monitored
Ignition on.

Set Condition
The VIN has not been programmed into the PCM. One Trip Fault. Three good trips to turn off the MIL.

Possible Causes
- PROGRAMMING VIN INTO PCM
- PCM

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.

Diagnostic Test
1. PROGRAMMING VIN INTO THE PCM





Ignition on, engine not running.
Using the scan tool, program VIN into the PCM.
Start the engine.

NOTE: If the engine will not start, crank the engine over for 15 seconds. Crank at least 2 times with the ignition switch returning to the off position each time.

Allow the engine to reach normal operating temperature.
With the scan tool, read DTCs.

Does the DTC reset?
Yes >> Replace and program the Powertrain Control Module per Service Information.
Perform POWERTRAIN VERIFICATION TEST. Powertrain Verification Test
No >> The VIN has been successfully programmed into the PCM. Test is complete.
Perform POWERTRAIN VERIFICATION TEST. Powertrain Verification Test