Electronically Controlled Clutch (ECC)

C2206-VEHICLE CONFIGURATION MISMATCH

For a complete wiring diagram Refer to Diagrams/Electrical Electrical Diagrams


- When Monitored:

Continuously with the ignition on.

- Set Condition:

When the All Wheel Drive (AWD) Module detects an incorrect CAN messages from the Engine Control Module (ECM) or the Integrated Power Module (IPM).








Diagnostic Test


1. CHECK IF TIPM CAN BUS DTC'S ARE PRESENT

With the scan tool, read IPM DTCs.

Are there any IPM CAN BUS DTC's present?

Yes

- Perform AWD VERIFICATION TEST - VER 1. Verification Tests

No

- Go To 2



2. CHECK IF ENGINE DTC'S ARE PRESENT

With the scan tool, read Engine DTCs.

Are there any Engine DTC's present?

Yes

- Refer to the appropriate test.
- Perform AWD VERIFICATION TEST - VER. Verification Tests

No

- Using the schematics as a guide, check the AWD Module pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the AWD Module.
- Perform AWD VERIFICATION TEST - VER. Verification Tests