B2105

B2105-IGNITION UNLOCK RUN/START CONTROL CIRCUIT HIGH





For a complete wiring diagram consult Diagrams/Electrical.


- When Monitored:
With the ignition on.

- Set Condition:
The TIPM detects a short to voltage on the (F902) circuit.








Diagnostic Test


1. CHECK FOR ACTIVE DTC
With the scan tool, read the active DTC's.
Cycle the ignition switch from off to on, leaving the ignition on for a minimum of 30 seconds.
With the scan tool, read the active DTC's.
Does the scan tool display this DTC as active?

Yes


- This is and internal TIPM failure. Replace the TIPM.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test


No


- Go To 2




2. CHECK FOR VOLTAGE ON (F902) IGNITION OFF/RUN/START CIRCUIT
Turn the ignition off.
Disconnect the TIPM C5 harness connector.
Measure the voltage of the (F902) Ignition Off/Run/Start circuit.
Is voltage present?

Yes


- Repair the (F902) Ignition Off/Run/Start circuit for a short to voltage.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test


No


- Replace the TIPM.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test