B2317

B2317-WIPER HI/LOW CONTROL CIRCUIT LOW

For a complete wiring diagram consult Diagrams/Electrical.


- When Monitored:
- With the ignition on.
- Set Condition:
- When the TIPM detects a short/low condition.







Diagnostic Test


1. FUSED B+ CIRCUIT OPEN




NOTE: Check all fuses and circuit breakers before proceeding with the diagnosis of this DTC.

Turn the ignition on.
Remove the Wiper HI/LOW relay.
Measure the voltage at cavity 86 of the Wiper HI/LOW relay.
Is the voltage above 10.0 volts?

Yes


- Go To 2


No


- Check the Fused B+ circuit for an open.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test




2. WIPER HI/LOW RELAY
Turn the ignition off.
Replace the Wiper HI/LOW relay with and known good relay.
Turn the ignition on.
With the Scan Tool, clear all TIPM DTC's.
Turn the Wipers ON then OFF.
With the Scan Tool, read the Wiper DTC's.
Does the Scan Tool read: B2313-WIPER HI/LOW CONTROL CIRCUIT LOW?

Yes


- Go To 3


No


- Replace the Wiper HI/LOW relay.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test




3. TOTALLY INTEGRATED POWER MODULE
Turn the ignition off.
Disconnect the TIPM C1 connector.
Measure the voltage on cavity 29 (Wiper HI/LOW Relay Control) of the TIPM.
Is the voltage above 10.0 volts?

Yes


- Replace the TIPM.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test


No


- Test Complete.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test