Passive Entry Module (PEM)

B2205-00-ORIGINAL VIN MISSING/MISMATCH

For a complete wiring diagram, refer to the Wiring Information. Electrical Diagrams

- When Monitored:
During a Passive Entry or Keyless Go event.

- Set Condition:
The Passive Entry Module (PEM) will receive and monitor the gated VIN message from the PCM and record the VIN if different from the last VIN. If the module was used on a previous vehicle, the VIN will be set to that vehicle and the module will have to be replaced.





CHECK FOR ACTIVE DIAGNOSTIC TROUBLE CODE (DTC)
1. Using the FOBIK, turn the ignition on.
2. Using the scan tool, record and erase the DTCs.
3. With the scan tool, select: PEM, More Options and System Tests.
4. Perform the PEM LF Antenna Verification Tests.
5. With the scan tool, read the DTCs.

Does the scan tool display: B2205-00-ORIGINAL VIN MISSING/MISMATCH as active?

Yes

- Verify that the PEM receives a valid VIN.
- Verify that the PEM is correctly programmed.
- If the above conditions are met, replace the PEM module.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
- Perform the BODY VERIFICATION TEST. Body Verification Test.