Rear

REMOVAL






NOTE: The rear timing belt cover has O-rings to seal the water pump passages to cylinder block. Do not reuse the O-rings.

1. Disconnect and isolate the negative battery cable.
2. Drain the cooling system Service and Repair.
3. Remove timing belt (4) Timing Belt & Sprockets - Removal.
4. Remove the right (2) and left (7) camshaft sprockets Timing Belt & Sprockets - Removal.





5. Remove three power steering pump mounting bolts (1) through access holes in pulley and reposition the power steering pump (3).





6. Raise and support the vehicle.
7. Remove the front belly pan Belly Pan - Removal.
8. Remove upper most mounting bolt (2) from generator (1).
9. Remove generator bracket bolt (3) and remove bracket (4).
10. Remove lower mounting bolts (2) and reposition the generator (1).






NOTE: Bolt 3 securing the A/C compressor to the engine cannot be fully removed until the compressor is positioned away from the cylinder block.

11. Fully loosen the bolt (3) that secures the A/C compressor (5) and automatic transmission cooler line bracket (4) to the cylinder block (6).

CAUTION: Use care not to deform or damage the automatic transmission cooler lines and retaining bracket when repositioning the A/C compressor.

12. Remove bolts (1 and 2) and reposition the A/C compressor.










13. Remove water pump mounting bolts (3).
14. Remove water pump.
15. Remove rear timing belt cover bolts (1, 2) and nuts (4).
16. Remove the rear cover.