B1462

B1462-CHANNEL 1 AUDIO SPEAKER OUTPUT CIRCUIT HIGH





For a complete wiring diagram, refer to the wiring information Electrical Diagrams.

- When Monitored:
With the ignition on.

- Set Condition:
The amplifier detects a short to battery condition on the output circuit.





1. CHECK FOR AN INTERMITTENT CONDITION
1. Turn the ignition on, then off, and then on again.
2. With the scan tool, read Amplifier DTCs.

Does the scan tool display active: B1462-CHANNEL 1 AUDIO SPEAKER OUTPUT CIRCUIT HIGH?

Yes

- Go To 2

No

- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform BODY VERIFICATION TEST. Body Verification Test

2. CHECK FOR VOLTAGE ON THE (X209) AMPLIFIED LEFT I/P SPEAKER (+) CIRCUIT




1. Turn the ignition off.
2. Disconnect the Amplifier C1 harness connector.
3. Disconnect the Amplified Left I/P Speaker harness connector.
4. Turn the ignition on.
5. Measure for voltage on the (X209) Amplified Left I/P Speaker (+) circuit.

Is the voltage above 10.0 volts?

Yes

- Repair the (X209) Amplified Left I/P Speaker (+) circuit for a short to voltage.
- Perform BODY VERIFICATION TEST. Body Verification Test

No

- Go To 3

3. CHECK FOR VOLTAGE ON THE (X299) AMPLIFIED LEFT I/P SPEAKER (-) CIRCUIT




1. Measure for voltage on the (X299) Amplified Left I/P Speaker (-) circuit.

Is the voltage above 10.0 volts?

Yes

- Repair the (X299) Amplified Left I/P Speaker (-) circuit for a short to voltage.
- Perform BODY VERIFICATION TEST. Body Verification Test

No

- Replace the amplifier.
- Perform BODY VERIFICATION TEST. Body Verification Test