Heated/Cooled Cupholder Switch - Removal

REMOVAL





1. Disconnect and isolate the negative battery cable.

NOTE: The heated/cooled cupholder switch is secured to the center floor console by four retaining tabs. Two retaining tabs on top and two on bottom of switch.

2. Using Trim Stick C-4755 (1) or equivalent, disengage the four retaining tabs that secure the heated/cooled cupholder switch (2) to the center floor console (3).

NOTE: Use care not to allow the wire harness connector for the heated/cooled cupholder switch to fall inside of the center floor console once the wire harness is disconnected.

3. Remove the heated/cooled cupholder switch from the center floor console and disconnect the wire harness connector from the switch.