Part 3

ASSEMBLY











71. Install low/reverse accumulator (1).










72. Install low/reverse accumulator plug (2).










73. Install low/reverse accumulator snap ring (1).










NOTE: Depending on engine application, some accumulators will have two springs, and others will have one spring. The springs are color-coded for application and year.

74. Install underdrive (2) and overdrive (4) accumulators and springs.










75. Install valve body (1) to transaxle. Rotate manual valve shaft fully clockwise to ease installation. Make sure park rod rollers are positioned within park guide bracket.










76. Install and tighten valve body-to-case bolts (1) to 12 Nm (105 in. lbs.).










77. Install oil filter (1) and new O-ring (2).










78. Apply a 1/8" bead of Mopar(R) ATF RTV (MS-GF41) (2) to oil pan (1) and immediately install to case.










79. Install oil pan-to-case bolts and tighten to 19 Nm (165 in. lbs.).
80. Install solenoid/pressure switch assembly (1) and gasket (2) to case.










81. Install and tighten solenoid/pressure switch assembly-to-transaxle case bolts (1) to 12 Nm (106 in. lbs.).
82. Install and tighten input and output speed sensors to case to 27 Nm (20 ft. lbs.).