Part 3

DISASSEMBLY











66. Using ordinary pliers, remove pivot shaft (3) and guide bracket assembly (2).










67. Inspect guide bracket components for excessive wear and replace if necessary.










NOTE: The Low/Reverse Clutch Piston has bonded seals which are not individually serviceable. Seal replacement requires replacement of the piston assembly.

68. Remove low/reverse clutch piston (1).










69. Remove low/reverse piston retainer-to-case screws (3).










70. Remove low/reverse piston retainer (1).










71. Remove low/reverse piston retainer-to-case gasket (2) , gasket holes must line up (1).










72. Using a hammer (2) and suitable drift (3), drive out inner output bearing cup (1).










73. Using bearing cup puller 6062A (1), remove outer output bearing cup.