Powertrain Control Module - Installation

INSTALLATION





1. If removed, install the rubber bumper onto the Powertrain Control Module (PCM).





2. If removed, position the bracket onto the PCM and install the two retaining screws. Tighten the screws securely.





3. Position the PCM and bracket to the vehicle.

NOTE: Prior to reconnecting the electrical connectors to the PCM, check the pins in the electrical connectors for misalignment and/or damage. Repair as necessary.

4. Connect the electrical connectors to the PCM.
5. Install the bolt that secures the PCM bracket to the cross support. Tighten the bolt to 9 Nm (80 in. lbs.).
6. Install the cowl panel cover Cowl Panel Cover - Installation.
7. Reconnect the negative battery cable.

NOTE: If a new PCM is installed, it must be programed with the original Vehicle Identification Number (VIN) and mileage. If this is not done, a Diagnostic Trouble Code (DTC) may set.

8. If a new PCM is being installed, use a scan tool and program the new PCM with the original VIN and vehicle mileage.