Totally Integrated Power Module (TIPM) - Installation

INSTALLATION






CAUTION: The original Cab Compartment Node (CCN) and Powertrain Control Module (PCM) must be installed and functioning properly prior to powering up the new Totally Integrated Power Module (TIPM). The TIPM receives vehicle configuration data from the CCN and Vehicle Identification Number information from the PCM. If configuration information becomes lost or corrupted, the data can be obtained from DealerCONNECT

NOTE: A battery reconnect procedure must be performed anytime the battery has been disconnected. Battery System - Battery Reconnection .

1. Position Totally Integrated Power Module (TIPM) to vehicle. Engage the three retaining clips.





2. Disengage the outboard retaining clip and rotate the TIPM to access wire harness connectors.
3. Connect electrical harness connectors to TIPM.





4. Connect battery cable to TIPM. Tighten the nut to 20 - 28 Nm (15 - 21 ft. lbs.).
5. Close the battery cable nut cover.





6. Connect negative battery cable (2).

7. Insert the ignition key and turn it to the RUNposition and wait twenty seconds. The TIPM will collect the necessary vehicle configuration and VIN data from the CCN and PCM at this time. After twenty seconds turn the ignition key to the OFFposition and then back to the ONposition and verify proper vehicle systems operation.