B2228

B2228-WIN INTERNAL - RKE RECEIVER



- When Monitored:
With the ignition on.





VERIFY THAT THE DIAGNOSTIC TROUBLE CODE (DTC) IS ACTIVE
1. Turn the ignition on.

NOTE: Before continuing, review and check for the following:
- Review the repair history of the vehicle.
- Make sure that the vehicle has the correct PCM and WIN installed by verifying the part numbers.
- With the scan tool, make sure that the PCM and WIN are programmed correctly. Compare the PCM VIN to the WIN VIN and make sure the two VINs match.

2. With the scan tool, erase the DTCs.
3. Perform three ignition cycles, leaving the ignition switch on for a minimum of one minute per cycle.
4. With the scan tool, read the DTCs.

Does the DTC reset?

Yes

- Replace the Wireless Ignition Node (WIN). If this vehicle is equipped with a Steering Column Lock Module (BUX), it must also be replaced with the WIN. When replacing the WIN and the Steering Column Lock Module (ELV), the WIN MUST be programmed BEFORE the Steering Column Lock Module (ELV) is programmed. .
- Replace and program the Wireless Ignition Node (WIN). . Wireless Ignition Node Receiver - Removal
- Replace and program the Steering Column Lock Module (ELV). .
- Perform the WIN VERIFICATION TEST. Wireless Ignition Node (WIN) Verification Test.

No

- Perform the WIRELESS IGNITION NODE (WIN) INTERMITTENT TEST. . Initial Inspection and Diagnostic Overview