Instrument Panel

INSTRUMENT PANEL

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.





1. Disconnect and isolate the battery negative cable.
2. Remove the radio from the instrument panel. Radio - Removal.
3. Reach through and below the radio opening of the instrument panel to access and disconnect the instrument panel wire harness connector from the antenna connector receptacle (1).
4. Remove the two screws (3) that secure the antenna (2) to the instrument panel base trim substrate.
5. Remove the antenna from the instrument panel.