Instrument Panel

INSTRUMENT PANEL

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.





1. Reach through and below the instrument panel radio opening to position the antenna (2) to the instrument panel base trim substrate.
2. Install and tighten the two screws (3) that secure the antenna to the instrument panel. Tighten the screws securely.
3. Reconnect the instrument panel wire harness connectors to the antenna connector receptacle (1).
4. Reinstall the radio into the instrument panel. Radio - Installation.
5. Reconnect the battery negative cable.