Crankshaft Position Sensor: Service and Repair

CRANKSHAFT POSITION SENSOR

Removal Procedure




1. Disconnect the negative battery cable.
2. Remove the power steering pump, if equipped.
3. Remove the A/C compressor. Refer Automatic Temperature Control Heating, Ventilation, and Air Conditioning System.
4. Remove the rear A/C compressor mounting bracket bolts and the rear A/C compressor mounting bracket.
5. Remove the accessory mounting bracket by removing the bolts.




6. Disconnect the crankshaft position (CKP) sensor connector.
7. Remove the CKP sensor retaining bolt.
8. Gently rotate and remove the CKP sensor from the engine block.

Installation Procedure




1. Insert the CKP sensor into the engine block.
2. Install the CKP sensor retaining bolt.

Tighten: Tighten the crankshaft position sensor retaining bolt to 10 Nm (89 lb-in).

3. Connect the CKP sensor connector.
4. Install the accessory mounting bracket with the bolts.

Tighten: Tighten the accessory mounting bracket bolts to 35 Nm (26 lb.ft).




5. Install the rear A/C mounting bracket.

Tighten: Tighten the rear A/C mounting bracket bolts to 35 Nm (26 lb.ft).

6. Install the A/C compressor. Refer to Automatic Temperature Control Heating, Ventilation, and Air Conditioning System.
7. Install the power steering pump. Refer to Power Steering Pump.
8. Connect the negative battery cable.