Windshield Washer Pump(S)

(Typical)




Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the front left wheel.
3. Remove the bolts and the screws and the front wheel well splash shield.
4. Disconnect the electrical connector.
5. Disconnect the washer hose from the washer pump.
6. Remove the washer pump.




Installation Procedure
1. Install the washer pump.
2. Connect the washer hose to the washer pump.
3. Connect the electrical connector.

NOTE: Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent premature corrosion.

4. Install the front wheel well splash shield with the bolts and the screws.

Tighten
Tighten the front wheel well splash shield bolts to 1.5 Nm (13 lb.in).

5. Install the front left wheel.
6. Connect the negative battery cable.