Three-Point CLR Rear Outboard Seat Belt (Typical)

Removal Procedure




1. Open the luggage compartment.
2. Remove the luggage compartment wheelhouse trim panel. Refer to Interior Trim.
3. Remove the bolt and the luggage compartment seat belt retractor.




4. Remove the C-pillar trim. Refer to Interior Trim.
5. Remove the bolt and the C-pillar seat belt anchor.




6. Remove the rear seat cushion. Refer to Seats.
7. Remove the bolt and the floor seat belt anchor.
8. Remove the seat belt.

Installation Procedure





NOTE: Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent premature corrosion.

1. Install the luggage compartment seat belt retractor with the bolt.
Tighten
Tighten the seat belt retractor bolt to 38 Nm (28 lb.ft).




2. Feed the free end of the seat belt from the luggage compartment through the deck lid sill plate.
3. Install the floor seat belt anchor with the bolt.
Tighten
Tighten the seat belt anchor bolt to 38 Nm (28 lb.ft).

4. Install the rear seat cushion. Refer to Seats.




5. Install the C-pillar seat belt anchor with the bolt.
Tighten
Tighten the seat belt anchor bolt to 38 Nm (28 lb.ft).

6. Install the C-pillar trim. Refer to Interior Trim.
7. Install the luggage compartment wheelhouse trim panel. Refer to Interior Trim.