Sliding Door Procedure

SLIDING DOOR PROCEDURE

1. Remove the door upper frame trim molding.

2. Disengage the clips holding the trim panel around the perimeter of the door and separate the trim panel from the vehicle.

3. Loosen the screws holding the rear of the stop bumper to the door. Remove the screw holding the front of the stop bumper to the door and separate the stop bumper from the vehicle.





4. with the sliding door ajar, disengage the clip holding the rear latch release link to the latch/lock control, refer to Figure 1, and separate the link from the control.

5. Disengage the clip holding the outside door handle link to the latch/lock control.

6. Disengage the clip holding the inside release bellcrank link to the latch/lock control.

7. Disengage the clip holding the lock cylinder link to the latch/lock control and separate the lock cylinder link from the latch/lock control.

8. Disengage the hold open latch cable ball end from the latch/lock control and disengage the lock tabs holding the hold open latch cable case to the latch/lock control.

9. Loosen the bolts holding the latch/lock control to the sliding door.

10. Disengage the wire connector from the power door lock motor.

11. Separate the latch/lock from the vehicle.

12. Remove the screws attaching the power lock motor to the latch lock control and separate the motor from the control.

13. Install the new sliding door power lock motor (P/N 4675782) by reversing the previous steps.

NOTE:
PLACE THE CLIP FOR THE OUTSIDE RELEASE HANDLE LINK ATTHE BOTTOM OF THE SLOT BEFORE INSERTING THE LINK. PLACE THE CLIP FOR THE INSIDE RELEASE BELLCRANK LINK AT THE TOP OF THE SLOT BEFORE INSERTING THE LINK. PUSH THE REAR LATCH RELEASE LINK TO ITS FULL REARWARD POSITION BEFORE INSERTING IT INTO ITS CLIP ON THE LATCH/LOCK CONTROL.

14. Repeat steps 1 thru 13 for the other sliding door if required.

NOTE:
IF INTERMITTENT SLIDING DOOR POWER LOCK OPERATION EXISTS, REFER TO TECHNICAL SERVICE BULLETIN 08-40-95.