B2142

B2142 IGNITION OFF DRAW (IOD) FUSE NOT PRESENT

For a complete wiring diagram refer to Diagrams/Electrical.

- When Monitored:

With the Ignition on. This DTC will set only if vehicle has less that 50 miles on it. After 50 miles, DTC B219F will set.

- Set Condition:

IOD Fuse not installed in the TIPM.





Diagnostic Test

1. CHECK FOR ACTIVE DTC

With the scan tool, record and erase DTC's.

Cycle the ignition switch from off to on, leaving the ignition off for a minimum of 30 seconds.

With the scan tool, read the active DTC's.

Does the scan tool display this DTC as active?

Yes

- Go To 2

No

- If the DTC is stored, check for an intermittent condition. Using the wiring diagram/schematic as a guide, visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.

2. IOD FUSE INSTALLED

Verify IOD Fuse installed in TIPM

Is IOD Fuse present?

Yes

- Go To 3

No

- Install the IOD Fuse.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test

3. IOD FUSE BLOWN CHECK

Is IOD Fuse blown?

Yes

- Replace the IOD Fuse.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test

No

- Test complete.