B2376

B2376-REAR WIPER SWITCH INPUT CIRCUIT

For a complete wiring diagram refer to Diagrams/Electrical.

- When Monitored:
- With the ignition on.
- Set Condition:
- When the TIPM detects a short/low condition on the Rear Wiper Motor Control circuit.





Diagnostic Test

1. INTERMITTENT CONDITION

Turn the ignition on.

With the Scan Tool, clear all TIPM DTC's.

Turn the Washers on.

With the Scan Tool, read the Wiper/Washers DTC's.

Does the Scan Tool read: B2376-REAR WIPER SWITCH INPUT CIRCUIT?

Yes

- Go To 2

No

- The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

2. REAR WIPER MOTOR

Turn the ignition off.

Disconnect the Rear Wiper Motor connector.

Turn the ignition on.

With the Scan Tool, read the DTC's.

Does the Scan Tool read: B2376-REAR WIPER SWITCH INPUT CIRCUIT?

Yes

- Go To 3

No

- Replace the Rear Wiper Motor.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

3. (W13) REAR WIPER MOTOR CONTROL CIRCUIT SHORTED

Turn the ignition off.

Disconnect the Rear Wiper Motor harness connector.

Disconnect the TIPM C6 harness connector.

Measure the resistance between the (W13) Rear Wiper Motor Control Circuit and ground in the TIPM.

Is the resistance below 5.0 ohms?

Yes

- Repair the (W13) Rear Wiper Motor Control Circuit for a shorted condition.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

No

- Replace the Totally Integrated Power Module.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test