C121A

C121A-STEERING ANGLE SENSOR NOT INITIALIZED

For a complete wiring diagram Refer to Diagrams/Electrical. Electrical Diagrams


- When Monitored:

With the ignition on.

- Set Condition:

When the Anti-Lock Brake Module detects a low voltage at the Steering Angle Sensor or Steering Angle Sensor failure.







Diagnostic Test


1. CHECK FOR A DTC C121A-STEERING ANGLE SENSOR NOT INITIALIZED

NOTE: This DTC must be active for the results of this test to be valid.

Turn the ignition on.

With the scan tool, read and record DTCs.

With the scan tool, read and record Freeze Frame information.

With the scan tool, erase DTCs.

Road test the vehicle over 30 km/h (19 mph) for at least 30 seconds.

With the scan tool, read and record DTCs.

Does the scan tool display: C121A-STEERING ANGLE SENSOR NOT INITIALIZED?

Yes

- Go To 2

No

- Perform the ABS Intermittent Condition diagnostic procedure. ABS Intermittent Condition Test
- Refer to the ABS-INTERMITTENT CONDITION TEST. ABS Intermittent Condition Test


2. CHECK THE TERMINALS/CONNECTORS/WIRING HARNESS FOR DAMAGE

Check the Steering Angle Sensor installation.

Check all related wiring for bruised, chafed, pierced, or partially broken wires.

Check all related connectors for broken, bent, pushed out, or corroded terminals.

Were any problems found?

Yes

- Repair as necessary.
- Perform ABS VERIFICATION TEST. ABS Verification Test

No

- Go To 3


3. CHECK THE VOLTAGE ON THE (F943) FUSED B(+) CIRCUIT





Turn the ignition off.

Disconnect the Steering Control Module harness connector.

Turn the ignition on.

Measure the voltage of the (F943) Fused B(+) circuit.

Is the voltage above 10 volts?

Yes

- Go To 4

No

- Repair the (F943) Fused B(+) circuit for an open.
- Perform ABS VERIFICATION TEST. ABS Verification Test


4. CHECK THE RESISTANCE OF THE (Z385) GROUND CIRCUIT





Turn the ignition off.

Disconnect the Steering Control Module harness connector.

Measure the resistance between the (Z385) Ground circuit and ground.

Is the resistance below 5.0 ohms?

Yes

- Replace the Steering Control Module.
- Perform ABS VERIFICATION TEST. ABS Verification Test

No

- Repair the (Z385) Ground circuit for an open.
- Perform ABS VERIFICATION TEST. ABS Verification Test