P060D

P060D-ETC LEVEL 2 APP PERFORMANCE

For a complete wiring diagram refer to Diagrams/Electrical.


- When Monitored:

Throttle motor is powered and no matured faults related to APP Sensors.

- Set Condition:

When secondary software determines that APPS 1 and APPS 2 signals do not match for a period of time. One trip fault. ETC lamp will flash







Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.


Diagnostic Test


1. PROGRAM THE POWERTRAIN CONTROL MODULE

Verify the PCM is at the latest calibration (flash level).


NOTE: An intermittent loss of power to the PCM without performing an ETC Relearn procedure may cause this DTC to set.

Flash the Powertrain Control Module if any updates are available.

Start the engine.

Allow the engine to reach normal operating temperature.

Operate the accelerator pedal. (do not exceed 3500 rpm)

With a scan tool, select View DTCs.


NOTE: Diagnose any other DTCs that may have set with the P060D.

Does this DTC reset by itself?

Yes

- Replace and reprogram the Powertrain Control Module.
- Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test

No

- Test Complete.