P0700

P0700-TRANSMISSION CONTROL SYSTEM (MIL REQUEST)

For a complete wiring diagram refer to Diagrams/Electrical.


- When Monitored:

Ignition on and battery voltage greater than 10 volts.

- Set Condition:

An active DTC is stored in the TCM. One Trip Fault. Three good trips to turn off the MIL.







Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.


Diagnostic Test


1. DTC PRESENT IN EATX CONTROLLER

This is an informational DTC letting you know that a DTC(s) is stored in the Transmission Control Module.

Erase this DTC from the PCM after all Transmission DTC(s) have been repaired.

Using a scan tool, read the Transmission Controller DTC and perform the appropriate test.

PCM Diagnostic Information complete.

Continue

- Test Complete.