B1D69

B1D69-ADJUSTABLE PEDAL INHIBIT CIRCUIT HIGH





For a complete wiring diagram Refer to Diagram/Electrical. Electrical Diagrams

- When Monitored:

With the ignition on.

- Set Condition:

When the Adjustable Pedal Control circuit fails in the Totally Integrated Power Module (TIPM).





Diagnostic Test

1. DTC IS ACTIVE

Start the engine and allow it to idle.

Move the Adjustable Pedals Switch to each position several times.

With the scan tool, read the TIPM DTCs.

Is the status Active for this DTC?

Yes

- Go To 2

No

- Go To 5
- Perform the BODY VERIFICATION TEST-VER 1. Verification Tests

2. (F504) FUSED IGNITION SWITCH OUTPUT CIRCUIT FOR VOLTAGE





Turn the ignition off to the lock position.

Disconnect the Adjustable Pedals Switch harness connector.

Using a 12-volt test light connected to ground check the Fused Ignition Switch Output circuit in the Adjustable Pedal Switch harness connector.

Does the test light illuminate brightly?

Yes

- Go To 3

No

- Replace the Adjustable Pedals Switch.
- Perform the BODY VERIFICATION TEST-VER 1. Verification Tests

3. (F504) FUSED IGNITION SWITCH OUTPUT CIRCUIT SHORTED TO VOLTAGE





Disconnect the TIPM C3 harness connector.

Using a 12-volt test light connected to ground check the Fused Ignition Switch Output circuit in the Adjustable Pedal Switch harness connector.

Does the test light illuminate brightly?

Yes

- Repair the (F504) Fused Ignition Switch Output circuit for a short to voltage.
- Perform the BODY VERIFICATION TEST-VER 1. Verification Tests

No

- Go To 4

4. TOTALLY INTEGRATED POWER MODULE (TIPM)

Using the wiring diagram/schematic as a guide, inspect all wiring and connectors that pertain to this circuit.

Were any problems found?

Yes

- Repair as necessary.
- Perform the BODY VERIFICATION TEST-VER 1. Verification Tests

No

- Perform the BODY VERIFICATION TEST-VER 1. Verification Tests

5. INTERMITTENT WIRING AND CONNECTORS

The conditions necessary to set this DTC are not present at this time.

Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.

While monitoring the scan tool data relative to this circuit, wiggle test the wiring and connectors.

Look for the data to change or for the DTC to reset during the wiggle test.

Were any problems found?

Yes

- Repair as necessary.
- Perform the BODY VERIFICATION TEST-VER 1. ABS Verification Test

No

- Test complete.