C1465

C1465-FRONT AXLE DISCONNECT CONTROL CIRCUIT HIGH





For a complete wiring diagram, refer to the Wiring Information Electrical Diagrams.

- When Monitored:
The ignition on and the T-Case Switch in the 4W/LO position.

- Set Condition:
The TIPM detects the Front Axle Lock Control circuit is shorted high.





1. ACTIVE DTC

CAUTION: Before removing the TIPM harness connectors, clean the connector and locking cam area of dirt and debris. Failure to do so can result in the connector being jammed or damage to the locking cams on the harness connector or module. Do not force the assist arm when releasing or installing the harness connector.

1. Ignition on, engine not running.
2. With the scan tool, read the TIPM DTCs.

Is the status Active for this DTC?

Yes

- Go To 2

No

- Go To 6

2. (G304) FRONT AXLE LOCK CONTROL CIRCUIT SHORTED TO VOLTAGE




1. Turn the ignition off to the lock position.
2. Disconnect the TIPM C2 harness connector.
3. Disconnect the FAD harness connector.
4. Ignition on, engine not running.
5. Measure the voltage between ground and the (G304) Front Axle Lock Control circuit.

Does the voltmeter indicate voltage present?

Yes

- Repair the short to voltage in the (G304) Front Axle Lock Control circuit.
- Perform the TRANSFER CASE VERIFICATION TEST Transfer Case Verification Test.

No

- Go To 3

3. FRONT AXLE DISCONNECT (FAD) MODULE SHORTED TO VOLTAGE




1. Turn the ignition off to the lock position.
2. Connect the FAD harness connector.
3. Ignition on, engine not running.
4. Measure the voltage between ground and the (G304) Front Axle Lock Control circuit.

Does the voltmeter indicate any voltage present?

Yes

- Go To 5

No

- Go To 4

4. TOTALLY INTEGRATED POWER MODULE (TIPM)
1. Using the wiring diagram/schematic as a guide, inspect all wiring and connectors that pertain to this circuit.

Were any problems found?

Yes

- Repair as necessary.
- Perform the TRANSFER CASE VERIFICATION TEST Transfer Case Verification Test.

No

- Replace the Totally Integrated Power Module (TIPM).
- Perform the BODY VERIFICATION TEST Body Verification Test.

5. FRONT AXLE DISCONNECT (FAD) MODULE
1. Using the wiring diagram/schematic as a guide, inspect all wiring and connectors that pertain to this circuit.

Were any problems found?

Yes

- Repair as necessary.
- Perform the TRANSFER CASE VERIFICATION TEST Transfer Case Verification Test.

No

- Replace the Front Axle Disconnect (FAD) Module.
- Perform the TRANSFER CASE VERIFICATION TEST Transfer Case Verification Test.

6. INTERMITTENT WIRING AND CONNECTORS
1. The conditions necessary to set this DTC are not present at this time.
2. Using the schematics as a guide, inspect the wiring and connectors specific to this circuit.
3. Wiggle test the wiring harness and connectors while checking for shorted and open circuits.
4. Using the scan tool, monitor the data related to this circuit while performing the wiggle test. Look for the data to change or for the DTC to reset.

Were there any problems found?

Yes

- Repair as necessary.
- Perform the TRANSFER CASE VERIFICATION TEST Transfer Case Verification Test.

No

- Test Complete.