P0700

P0700-TRANSMISSION CONTROL SYSTEM (MIL REQUEST)

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
With the ignition on and battery voltage above 10.0 Volts.

- Set Condition:
An active DTC is stored in the Transmission Control Module. This is a one trip fault. Three good trips to turn off the MIL Lamp.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Pre-Diagnostic Troubleshooting Procedure.
DTC PRESENT IN EATX CONTROLLER
1. This is an information only DTC to inform that a DTC(s) is stored in the Transmission Control Module.
2. Erase the DTC in the PCM after all Transmission DTC(s) have been repaired.
3. With the scan tool, View all Transmission DTCs and perform the appropriate diagnostic procedure.

PCM diagnostic information

Continue

- Test complete.