Mopar Threadmaker

Three new Mopar adhesives and sealants are now available for service use. They are:

Mopar Threadmaker PN 4467725

Mopar Bondall Gel PN 4467709

Mopar Flowable Windshield and Glass Sealant PN 4467708

This bulletin describes the proper application and use of these products.

Mopar Threadmaker PN 4467725

Mopar Threadmaker is a two-part epoxy product that is used to restore damaged or stripped threads in certain applications. This material is designed to repair stripped threads in noncritical areas. It is quick, easy, and requires no special tools. It is also easy to use in limited access areas where removal of a component may be difficult.

INSTRUCTIONS FOR USE

1. Thoroughly clean the area to be repaired with Mopar Brake and Carburetor Cleaner (PN 4318037 or equivalent).

2. Apply release agent to the bolt threads.

3. Mix thoroughly a 50-50 blend of the two-part epoxy.

4. Place material into bolt hole and screw bolt into hole.

5. Wipe off excess material and wait for 15 minutes.
6. After 15 minutes, torque to normal specification.

NOTE: TEMPERATURES BELOW 65~F MAY REQUIRE LONGER CURE TIME.

7. If the application requires Mopar Lock-N-Seal or Stud-NBearing mount thread locking compounds, wait for the Threadmaker to cure 15 minutes. Then, remove the bolt, apply the thread locking compound, and torque to specification.
SUGGESTED APPLICATIONS FOR MOPAR THREADMAKER
Head Lamp Trim Rings

Carburetor Cover Screws

Brackets and Fittings Attached to the Intake Manifold

Ignition Coil Screws

Wiper Motor Screws

Battery Tray Bolts

Valve Cover Attaching Bolts

Timing Chain or Belt Cover Attaching Bolts

Thermostat Housing Attaching Bolts


Oil Pump Attaching Screws
Speedometer Cable Fittings

Intake Manifold Bolts

Distributor Clamp Bolts


Windshield Washer Bottle Screws

Oil Dipstick Screws

Oil Pan to Engine Block Bolts

Water Pump Attaching Bolts

Carburetor Attaching Bolts


Crankshaft Seal Retainer Attaching Bolts

Oil Pan Drain Plug
APPLICATIONS NOT RECOMMENDED

Steering Assemblies and Attaching Bolts

Main Bearing Cap Bolts

Camshaft Oil Galley Pipe Plugs

Timing Belt Tension Screw

Wheel Lugs


Spark Plugs
Brake Assemblies


Connecting Rod Bolts

Head Bolts

Clutch Plate Attaching Screws

Suspension Components and Attaching Bolts
DO NOT USE in any application where temperatures are expected to exceed 300~F., or with bolt sizes of 1 inch diameter or larger.