Sunroof / Moonroof: Adjustments
SUNROOF FIT ADJUSTMENTIf the roof glass lid must be adjusted forward/backward or to right/left
1. Close the roof glass lid to the fully tilt closed position.
2. Loosen the nuts (six) and move the roof glass lid forward/backward or left/right.
3. If a forward/backward adjustment has been made check to be sure that the sliding roof assembly's guide and the link's reference hole are positionally aligned.
NOTE: If the condition is not corrected by only an adjustment by the installation nut, there is a deviation of the fully closed position of the roof glass lid and the motor's fully closed position, so remove and check the motor.
If the roof and roof glass lid are not parallel
1. If the deviation is approximately 1 mm (.04 in.). make the forward/backward or left/right adjustment by the same procedure.
2. If the deviation is approximately 2 mm (.08 in.), remove the motor and advance the cable (at the side where the gap is larger) one pitch.
NOTE: There will be movement of 2.5 mm (0.098 in.) for one pitch of the cable.
If the height of the roof and the roof glass lid must be adjusted
1. Close the roof glass lid to the fully tilt closed position.
2. Loosen the six nuts.
3. Adjust by increasing or decreasing the number of adjustment plates.