Code 14 Analog G Sensor System

The SDU monitors the analog G sensor output and outputs this code when it detects a sensor failure, abnormal sensor characteristics or abnormal sensor output.

Probable cause of trouble

SDU out of order








Caution

1. After the ignition switch has been placed at the LOCK position and the negative (-) terminal of the battery has been disconnected, wait for more than 60 seconds before starting work. Wind a tape around the disconnected (-) terminal for insulation.

2. To unlock the SDU connector, put a flat tip screwdriver on the lock spring (metallic portion) of the lock lever as shown, and press it horizontally toward the inside of the unit. In this case, do not force the lock lever up. Do not put the flat tip screwdriver in the clearance between the lock lever and lock spring (metallic portion).

Since a defective analog G sensor in the SDU is suspected, replace the SDU.