Fuel Injector Control Module: Service and Repair

FUEL INJECTOR CONTROL MODULE

Removal and Installation

1. Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation (PMI) procedure.

2. NOTICE: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.

Turn the ignition switch to the OFF position.

3. Remove the bolts and position the degas bottle aside.






4. NOTICE: Make sure both latches are released before removing the electrical connectors or connector damage can occur.

Disconnect the fuel injector control module (FICM) electrical connectors. Position the wiring harness aside.






5. Disconnect the bulkhead connector and position aside.






6. Remove the bolts and the FICM.






7. To install, reverse the removal procedure.

If the fuel injector control module was replaced, restore the module configuration. Carry out the module configuration steps ofthe Programmable Module Installation (PMI) procedure.