Side Impact Sensor - C-Pillar

SIDE IMPACT SENSOR - C-PILLAR







Removal and Installation

WARNING:
- Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
- Vehicle sensor orientation is critical for correct system operation. If a vehicle equipped with an air bag supplemental restraint system (SRS) is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Install and correctly position the sensor or any other damaged supplemental restraint system (SRS) components whether or not the air bag is deployed. Failure to follow these instructions may result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a SRS fault.
- The supplemental restraint system (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
- Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.

1. Fold down the rear seat backrest.
2. Depower the system.







3. Position aside the quarter trim panel.
- Pull out on the quarter trim panel at the C-pillar to release the retaining clip to access the C-pillar side impact sensor.

4. Disconnect the side impact sensor electrical connector.

5. WARNING: The tightening torque of the air bag side impact sensor retaining bolt is critical for correct system operation. Failure to follow tightening instructions may result in serious personal injury.

NOTE:
- Note the position of the 2 side impact sensor locating tabs for installation.
- Make sure the C-pillar and side impact sensor mating surfaces are clean and free of foreign material.

Remove the bolt and the side impact sensor.
- To install, tighten to 11 Nm (8 lb-ft).

6. To install, reverse the removal procedure.
7. Repower the system.