Seat Position Sensor: Service and Repair

SEAT POSITION SENSOR







Removal and Installation

WARNING:
- Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The supplemental restraint system (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
- Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.

All seats
1. Raise the driver seat and then position it to the middle of the track.
2. Depower the system.
3. Remove the driver seat.
4. Disconnect the seat position sensor electrical connector.

Power seats







5. Detach the wire harness routing pin-type retainer from the seat position sensor bracket.

All seats







6. Push apart then inward to release the seat position sensor locking clip.
7. Slide the seat position sensor rearward to release the 2 hooks from the bracket. Then remove the seat position sensor.
8. To install, reverse the removal procedure.
9. Repower the system.