Operation CHARM: Car repair manuals for everyone.

Test R: Injection Pressure Regulator (IPR)

PINPOINT TEST R: INJECTION PRESSURE REGULATOR (IPR)


Flow Chart:






This pinpoint test is intended to diagnose the following:
- harness circuits: IPR and VPWR
- IPR
- powertrain control module (PCM)

Injection Pressure Regulator (IPR) Solenoid Connector


Injection Pressure Regulator (IPR) Solenoid Connector:






PCM Connector


PCM Connector:





-----------------------------------------------
R1 : PRELIMINARY DIAGNOSIS FOR DIAGNOSTIC TROUBLE CODE (DTC) P2623

NOTE: This DTC does not set during crank mode

- Carry out a visual inspection.
- Retrieve and record all DTCs
- Record the freeze frame data
- Clear the DTCs.
- Carry out the KOEO and KOER self-test. Quick Test Description
- Is DTC P2623 present?






-----------------------------------------------
R2 : CHECK THE IPR SOLENOID RESISTANCE

- Ignition OFF.
- IPR Solenoid connector disconnected.
- Measure the resistance between:







- Is the resistance between 3 Ohm - 15 Ohm?






-----------------------------------------------
R3 : CHECK THE IPR SOLENOID VOLTAGE

- Ignition ON, engine OFF.
- Measure the voltage between:







- Is the voltage greater than 10.5 V?






-----------------------------------------------
R4 : CHECK THE IPR CONTROL CIRCUIT FOR A SHORT TO POWER

- Ignition OFF.
- PCM connector disconnected.
- Ignition ON, engine OFF.
- Measure the voltage between:







- Is any voltage indicated?






-----------------------------------------------
R5 : CHECK THE IPR CONTROL CIRCUIT FOR A SHORT TO GROUND

- Ignition OFF.
- Measure the resistance between:







- Is the resistance greater than 10 kOhm?






-----------------------------------------------
R6 : CHECK THE IPR CONTROL CIRCUIT FOR AN OPEN

- Measure the resistance between:







- Is the resistance less than 5 Ohm?






-----------------------------------------------
R7 : CHECK FOR CORRECT PCM OPERATION

- Disconnect all the PCM connectors.
- Visually inspect for:
- pushed out pins
- corrosion

- Connect all the PCM connectors and make sure they seat correctly.
- Carry out the PCM self-test and verify the concern is still present.
- Is the concern still present?