Autolock and Auto-Unlock Programming

Autolock and Auto-Unlock Programming

Programming the Autolock Feature

NOTE: This vehicle is not equipped with an Auto-Unlock feature.

NOTE: Make sure that the key is in the OFF position and the doors are closed and unlocked.

NOTE: When programming the autolock feature using the door lock lever method, the following steps must be carried out within 30 seconds or the procedure will need to be repeated. If the procedure needs to be repeated, wait 30 seconds between programming sessions.

1. NOTE: If the driver seat belt is not buckled, the Instrument Cluster (IC) will sound the seat belt warning chime instead of the autolock programming mode confirmation chime.

Buckle the driver seat belt.

2. Turn the ignition key from the OFF to the RUN position.

3. Push (lock) and pull (unlock) the driver door lock lever 3 times.

4. Turn the ignition key from the RUN to the OFF position.

5. Push (lock) and pull (unlock) the driver door lock lever 3 times.

6. Turn the ignition key to the RUN position. The IC sounds a chime to indicate that programming mode is entered.

7. To enable/disable the autolock feature, push (lock) and pull (unlock) the driver door lock lever one time to toggle the state of the autolock feature. The IC sounds 2 chimes if the autolock has been enabled and 1 chime if the autolock has been disabled.

8. Turn the ignition key to the OFF position.