Operation CHARM: Car repair manuals for everyone.
Home >> Ford Truck >> 2010 >> Transit Connect L4-2.0L >> Repair and Diagnosis >> Relays and Modules >> Relays and Modules - Powertrain Management >> Relays and Modules - Computers and Control Systems >> Engine Control Module >> Service and Repair

Engine Control Module: Service and Repair




Powertrain Control Module (PCM)









Removal

1. NOTE: PCM installation DOES NOT require new keys or programming of keys, only a Parameter Reset of the Passive Anti-Theft System (PATS).

Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to Information Bus.

2. Remove the Air Cleaner (ACL) outlet pipe and the ACL assembly. For additional information, refer to Fuel Delivery and Air Induction.

3. Disconnect the 3 PCM electrical connectors.

4. Remove the 2 bolts and the PCM.

Installation

1. Install the PCM and the 2 bolts.
- Tighten to 8 Nm (71 lb-in).

2. Connect the 3 PCM electrical connectors.

3. Install the ACL outlet pipe and the ACL assembly. For additional information, refer to Fuel Delivery and Air Induction.

4. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to Information Bus.

5. Reprogram the PATS. Carry out the Parameter Reset procedure. For additional information, refer to Antitheft and Alarm Systems. Passive Anti-Theft System (PATS)
pro multis · About Operation CHARM