Occupant Classification System Module (OCSM) - Power Seat Track

Occupant Classification System Module (OCSM) - Power Seat Track









Removal

NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.

NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

1. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures information.

2. Disconnect the Occupant Classification System Module (OCSM) electrical connector.

3. Remove the 2 screws and OCSM.

4. To install, reverse the removal procedure.

5. Repower the SRS. Do not prove out the SRS at this time. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures information.

6. Carry out the Occupant Classification System (OCS) System Reset procedure. For additional information, refer to Occupant Classification Sensor (OCS) System Reset Service and Repair in the General Procedures information.