Overhaul

Ignition Lock Cylinder













Assembly

NOTE: This lock cylinder cannot be disassembled. This procedure is for assembly only.

1. NOTE: The tumblers required can be determined from the vehicle keycode. If necessary, the factory keycode can be obtained from authorized dealership personnel.

Select the required tumblers according to the key cut depths for each position from A through F.





2. NOTE: Make sure that the tumbler and spacer indents align with the locking pin slot.

Install the ignition lock cylinder tumblers and spacers into the ignition lock cylinder barrel as follows:









3. Using a suitable tool (such as a center punch or chisel), crimp the ignition lock cylinder barrel to secure the tumbler retainer.





4. Apply the multi-purpose grease on the lock cylinder barrel in and around the locking pin slot and in the tumbler retainer.





5. NOTE: Install the key hole shield so that the wider land is covering the keyhole.

Install the ignition lock cylinder key hole shield





6. Place the locking pin into the locking pin slot.

7. Slide the ignition lock cylinder body onto the ignition lock cylinder barrel.

8. Install the ignition lock cylinder barrel retaining clip.

9. Install the ignition lock cylinder security clip noting its correct position.





10. Spray a small amount of the multi-purpose grease into the key hole.