Oil Pressure Sensor: Service and Repair

Engine Oil Pressure (EOP) Switch





Removal and Installation

NOTE: Removal steps in this procedure may contain installation details.

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Loosen the 4 retainers and remove the underbody shield.





3. NOTE: Apply thread sealant to the EOP (Engine Oil Pressure) switch threads.
Disconnect the Engine Oil Pressure (EOP) switch electrical connector.

- Remove the EOP (Engine Oil Pressure) switch.

- To install, tighten to 15 Nm (133 lb-in).






4. To install, reverse the removal procedure.