Window Glass - Front Door

Window Glass - Front Door

Removal

1. Remove the door speaker. REFER to Speaker - Door .

2. Position aside the water shield.

3. Remove the interior door window glass belt moulding.

4. Install the window control switch and position the door window glass to access the door window glass bolts.

5. Remove the 2 door window glass bolts.
- To install, tighten to 8 Nm (71 lb-in).





6. Tip the front of the glass downward and pull the front door window glass out through the top of the inboard side of the door.

Installation

1. NOTE: The front window motor must be initialized whenever the LH (Left Hand) or RH (Right Hand) (XLT, Limited) or LH (Left Hand) (base) front window motor is removed from the window regulator drum housing, a new window regulator is installed, a new window glass is installed, a new top run is installed or for any operation in which grease or lubricants are applied to the window regulator or glass run. REFER to Window Motor Initialization Testing and Inspection.
To install, reverse the removal procedure.