Cruise Control Servo Cable: Service and Repair

1. Disconnect speed control actuator cable from accelerator cable bracket.
2. Disconnect servo electrical connector from inside engine compartment.
3. Apply parking brake, then raise and support left front side of vehicle.
4. Remove left front wheel, then the inner fender splash shield.
5. Remove two vacuum hoses from servo.
6. Remove two servo mounting bracket-to-pillar attaching screws.
7. Remove two actuator cable cover-to-servo attaching nuts, then the cable and cover.
8. Remove servo-to-mounting bracket attaching nuts and the servo.
9. Reverse procedure to install.