Right Front

Removal

WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY AND BACKUP POWER SUPPLY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BATTERY GROUND CABLE AND BACKUP POWER SUPPLY MUST BE DISCONNECTED PRIOR TO SERVICING OR REPLACING ANY SYSTEM COMPONENTS.

NOTE: To repair stripped outboard sensor retaining screws, replace the sensor bracket with bracket Part No. 14B045, screw Part No. N806327-S190 (2 req'd) and nut Part No W620397-S36 (2 req'd). Tighten to 9-12 Nm (7-9 lb-ft).

1. Disconnect battery ground cable and backup power supply.
2. Remove air cleaner assembly.





3. Disconnect RH front sensor electrical connector and wiring retainer.
4. Remove sensor support bracket.
5. Remove four retaining screws and remove sensor.

Installation
1. Position RH front sensor and wire lead in vehicle and secure sensor to RH radiator support with four retaining screws. Tighten screws to proper specifications.
2. Install sensor support bracket.
3. Connect RH front sensor wire lead connector to wiring assembly connector and connect wiring retainers.
4. Install air cleaner assembly.
5. Connect backup power supply and battery ground cable.
6. Verify air bag indicator.