Rear

Removal

WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY AND BACKUP POWER SUPPLY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BATTERY GROUND CABLE AND BACKUP POWER SUPPLY MUST BE DISCONNECTED PRIOR TO SERVICING OR REPLACING ANY SYSTEM COMPONENTS.

1. Disconnect battery ground cable and backup power supply.
2. Remove rear seat cushion.
3. Remove quarter panel trim panel.
4. Remove two screws retaining rear sensor to B-pillar.
5. Remove rear sensor from inside B-pillar.
6. Disconnect the rear sensor wiring connector from wiring assembly connector and remove sensor.





Installation
1. Connect rear sensor wiring connector to wiring assembly connector.
2. Position sensor to inside of B-pillar. Install retaining screws. Tighten to 9-14 Nm (7-10 lb-ft).
3. Connect sensor electrical connector.
4. Install quarter panel trim panel. Install rear seat cushion. 5. Connect backup power supply and battery ground cable.
6. Verify air bag indicator.