Ignition Cable: Service and Repair

Spark Plug Wire Remover:

Special Service Tool(s)

REMOVAL

CAUTION
^ It is important to twist the spark plug wire boots while pulling upward to avoid possible damage to the spark plug wire.
^ Spark plug wires must be connected to the correct ignition coil terminal. Mark spark plug wire locations before removing them.

Spark Plug Wire Remover:

1. Using the special tool remove the spark plug wire from the spark plug using a twisting motion.







2. Squeeze the locking tabs and twist while pulling upward to disconnect the spark plug wires from the ignition coil.

INSTALLATION
1. To install, reverse the removal procedure.

CAUTION: Be sure to orient the spark plug boots so the spark plug wires do not contact the exhaust manifold.

NOTE: Apply Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A or equivalent meeting Ford specification ESE-M1C171-A to the inside of spark plug and ignition coil boots of the spark plug wire.