Countershaft

Countershaft

Special Tools And Equipment Part 1 Of 2:

Special Tools And Equipment Part 2 Of 2:

Special Tool(s)

Part 1 Of 3:

Part 2 Of 3:

Part 3 Of 3:

Disassembly and Assembly





1. Remove the thrust washer.





2. Using the special tool and a press, remove the countershaft rear bearing.





3. Using the special tool and a press, remove the countershaft front bearing.





4. Place the special tool in a vise. Position the countershaft extension in the tool with the sixth drive gear facing upward. Remove the fifth sixth shift fork.





5. Remove the sixth drive gear.





6. Remove the sixth drive gear needle bearing.





7. Remove the sixth drive gear synchronizer blocking ring.





8. Remove the spacer.





9. Remove and discard the fifth sixth synchronizer snap ring.





10. Using the special tool, press the fifth sixth synchronizer and the fifth drive gear off the shaft.





11. Remove the fifth drive gear needle bearing.





12. Using the special tool, remove the countershaft extension bearing.
13. Inspect the countershaft and countershaft extension.
^ Check the shaft surface for wear or damage. Install a new shaft as necessary.
^ Check the gear teeth for wear, pitting, scoring, spelling or fractures. Install new components as necessary.





14. Disassemble the fifth sixth gear synchronizer assembly.
15. Inspect the fifth sixth synchronizer.
^ Check for worn, nicked or broken teeth. Install a new synchronizer as necessary.
^ Check keys for wear or distortion. Install a new synchronizer as necessary.
^ Check springs for distortion. Install a new synchronizer as necessary.





16. Inspect the fifth sixth synchronizer blocking rings.
^ Check for wear or damage. Install new synchronizer blocking rings as necessary.
^ Check the clearance between the synchronizer blocking ring and the gear.
^ Position the blocking ring onto the gear. Make sure the correct blocking ring is measured with the correct gear and that the blocking ring is fully seated on the gear.
^ Insert a feeler gauge and measure the clearance, while applying pressure and rotating the blocking ring. The measurement should be the same around the entire circumference. If the clearance is less than 0.38 mm (0.015 inch), install new blocking rings.





17. Using the special tools, install the countershaft rear bearing.





18. Using the special tools, install the countershaft front bearing.





19. Using the special tools, install the countershaft extension bearing.
20. To assemble, reverse the disassembly procedure.
^ Assemble the synchronizer assembly before installing.