Gearshift Rail and Fork

Gearshift Rail and Fork

Disassembly and Assembly

Part 1 Of 2:

Part 2 Of 2:

1. Disassemble the first/second and third/fourth shift rail as follows:
^ Rotate the interlock plate until it is opposite of the shift links.
^ Slide off the third/fourth shift fork and shift link. Separate the link from the fork.
^ Slide off the first/second shift fork and shift link. Separate the link from the fork.
^ Remove the interlock plate.
^ Using a 5/32 inch drift and a hammer, remove and discard the roll pins. Slide the gear select solenoid lever and the selector pin from the shift rail.
2. Disassemble the fifth sixth and reverse shift rail as follows:
^ Using a 5/32 inch drift and a hammer, remove and discard the roll pins. Slide the collar and the reverse shift lever from the shift rail.
^ Slide off the fifth sixth shift lever and shift link.
3. Inspect the shift rail components.
^ Check the rails, shift forks, shift levers and shift links for wear or damage. Install new components as necessary.
^ Check the shift fork pads for wear. Install new pads as necessary.

Part 1 Of 2:

Part 2 Of 2:

4. To assemble, reverse the disassembly procedure.
^ Install new roll pins.