Transmitter

REMOTE TRANSMITTER PROGRAMMING

NOTE:
- A maximum of 4 remote transmitters can be programmed to the vehicle. Programming must be done at the same time for all the remote transmitters.
- Before entering the remote transmitter programming mode, make sure that the vehicle battery is fully charged and that the anti-theft system is not armed or triggered (if equipped).

1. Close all doors to make sure conflicting chimes do not sound during programming.
2. Turn the ignition switch from position I to position II 4 times within 6 seconds.
3. Turn the ignition switch to position 0.
4. A chime sounds that indicates that the learning mode has been accessed and it is possible to program the remote transmitters.
5. Within 10 seconds of the previous step, press any button on the remote transmitter being programmed until a chime is heard. This indicates a new remote transmitter code has been successfully programmed.
6. After each successful remote transmitter programming, another 10 second learning mode is automatically entered, up to a maximum of 4 times.
7. To program additional remote transmitters, repeat step 5.
8. The system will exit the learning mode if the ignition switch is turned to position III, no new remote transmitter is programmed during the 10 seconds, or if 4 remote transmitters have been programmed.

9. NOTE: An incorrect programming procedure does not affect the stored codes.

After successful programming, only the newly programmed remote transmitters will be accepted.

10. Test all the programmed remote transmitters, by activating and deactivating the remote locking and unlocking functions.