Ignition Switch: Service and Repair

Ignition Switch

Removal and Installation
1. Depower the Supplemental Restraint System (SRS).





2. Position the instrument panel lower panel aside.
^ Remove the instrument panel lower panel bolts.
^ Release the fastener.





3. Disconnect the hood release cable and the data link connector (DLC) from the instrument panel lower panel and remove the instrument panel lower panel.
^ Loosen the hood release cable nut.





4. Remove the steering column upper shroud.
^ Using a suitable tool, release the two clips (one on each side).





5. Remove the audio control switch (if equipped).
^ Using a suitable tool, release the locking tab.
^ Disconnect the electrical connector.





6. Remove the steering column lower shroud.
1. Release the steering column locking lever.
2. Remove the screws.





7. Disconnect the ignition switch and the LH multifunction switch electrical connectors.





8. Remove the ignition switch.
^ Release the clips.
9. To install, reverse the removal procedure.