Turn Signal Switch: Service and Repair

Steering Column Multifunction Switch

Removal and Installation





1. Remove the steering column upper shroud.
^ Using a suitable tool, release the 2 clips (one on each side).





2. Remove the audio control switch (if equipped).
^ Using a suitable tool, release the locking tab.
^ Disconnect the electrical connector.





3. Remove the steering column lower shroud.
1. Release the steering column locking lever (if equipped).
2. Remove the screws.





4. NOTE: LH multifunction switch shown, RH similar.

Disconnect the electrical connectors.





5. Remove the multifunction switch.
1. Press the locking tab.
2. Lift the multifunction switch upwards.

6. To install, reverse the removal procedure.