Transmitter

REMOTE KEYLESS ENTRY TRANSMITTER PROGRAMMING

NOTE:
- A maximum of 4 remote keyless entry (RKE) transmitters can be programmed to the vehicle. Programming must be done at the same time for all the RKE transmitters.
- Before entering the RKE transmitter programming mode, make sure the vehicle battery is fully charged and the anti-theft system is not armed or triggered (if equipped).
- The doors must be electronically unlocked before beginning the programming procedure.

1. Close all doors to make sure conflicting chimes do not sound during programming.
2. Turn the ignition switch from the OFF position to the RUN position 4 times within 6 seconds.
3. Turn the ignition switch to the OFF position.
4. A chime sounds that indicates the learning mode has been accessed and it is possible to program the RKE transmitters.
5. Within 20 seconds of the previous step, press any button on the RKE transmitter being programmed until a chime is heard. This indicates a new RKE transmitter code has been successfully programmed.
6. After each successful RKE transmitter programming, another 20 second learning mode is automatically entered, up to a maximum of 4 times.
7. To program additional RKE transmitters, repeat step 5.
8. The system exits the learning mode if the ignition switch is turned to the RUN position, no new RKE transmitter is programmed during the 20 seconds, or if 4 RKE transmitters are programmed.

9. NOTE: An incorrect programming procedure does not affect the stored codes.

After successful programming, only the newly programmed RKE transmitters are accepted.

10. Test all the programmed RKE transmitters, by activating and deactivating the remote locking and unlocking functions.